The Digital Wrench™ web site can also be accessed through the dealer web site at: NOTE:ĭistributors can access the dealer web site. Updates are released for Digital Wrench™ via the Internet at. If a newer update is available, it should be downloaded before using Digital Wrench™ (see “Digital Wrench™ Updates”). Proceed to to see if a newer update is available. Locate the version ID shown on the lower right side of the Digital Wrench™ start-up screen. NOTE: Versions and updates are subject to change. Knowing what Digital Wrench™ version and update is installed will help determine which updates are required. The serial number is located on the right side of the screen.

Open the configuration screen by clicking on the wrench icon. NOTE: Connecting the chassis power-up harness to the DC POWER TEST plug will power the DC chassis circuit. When battery power is connected successfully, the SmartLink status LED will blink on once.ĩ923311 - 2010-2012 PRO-RIDE RUSH/Switchback/RMK Service Manual NOTE: An internal relay within the harness prevents reverse polarity damage in the event the alligator clamps are connected to the battery incorrectly. Connect the chassis power- up harness to the ECU POWER connector.

Remove the protective cap from the Digital Wrench™ connector (A) and then connect the Vehicle Interface Cable to the diagnostic connector.Ĭonnect the chassis power-up harness to a fully charged 12VDC battery. The diagnostic/power connectors are located behind the left engine compartment door.Īssemble the SmartLink Module and attach the PC Interface Cable to your PC/laptop. ĭigital Wrench™ - Diagnostic / Power Connectors If you experience problems connecting to a vehicle or any Digital Wrench™ related problem, visit the Digital Wrench™ Knowledge Base for the most current troubleshooting information, FAQs, downloads and software updates at.

Polaris digital wrench 4.0 download